766 Bamboo Trail, Milford, NE 68405

This beautifully kept hobby farm has been in the family for over 150 years!  It is located less than 20 minutes west of Lincoln, NE.  Situated between Pleasant Dale and Milford in Seward County, these 30+/- acres have a lot to offer! Sitting only 500' from the county road, the original farmhouse was renovated in the year 2000 with over 700 square feet added to the living space and the addition of an attached 3 car garage.  At that time, the whole house was completely rewired and plumbed.  In January 2025, a new basement bathroom was completed and new carpet was installed in the upstairs bedrooms.  Other updates to the home include:  new roof 2018, new well pump 2021, new water heater 2021, high efficiency HVAC system 2023, epoxy floor in basement 2023, and a 5 camera security system 2023.    Six outbuildings on this property provide you with plenty of space to store all of your gear and equipment!  A 60'x60' pole barn is the perfect spot to store your mower, boat, small tractors, tools and everything in between.  This building is also home to an indoor lap pool with a heated floor!  The pool is 6 feet deep and is the perfect place to exercise year-round and a nice warm retreat when it's snowing outside!  This building is commercially wired with 100amp service. Heat for the pool room and the house is provided by a wood-fueled Central Boiler unit which was installed in 2023.  The boiler also received a recent upgrade in 2025 with the addition of a Raypak propane heater.   The boiler unit is incredibly efficient and has significantly reduced utility costs during the winter. The old detached garage was moved and converted into an insulated shed in the backyard which was used by pets as a nice warm place to escape the cold during winter months.  The detached garage also houses the controls for the 12-zone sprinkler irrigation system.    The 60'x40' equipment shed comes equipped with 14' sidewalls and a 20' door.  This building received a new roof in 2018. The poured concrete floors have a center drain and are thick enough to handle large equipment.  Commercially wired with 100amp service, it is ready for you and your welding gear.  The fully insulated woodworking shop features a dust collector and 60 gallon/155 PSI air compressor.  Seven air hookups are strategically located around the shop for convenient use.  A half-bathroom with its own hot water heater is also located in the woodworking shop along with 100amp service.  The space is heated by a propane furnace or a wood burning stove.